Forum Replies Created
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
Thanks a lot for your answer! I know about the director, but i wasn’t sure about the format. So it sends out the anolog signal on my mixracks outs, when i directly tie-line the consoles AES-IN to them?
Hello together,
sorry for this late reply! To finish this whole thing:
Pit thank you very much for the tip with the right click in the editor! I didn’t know about the copy function for the editor.
In the end this worked totally fine !!! Yesterday i used the new setup and everything worked!!
Thanks!!
SWu
Hi Chris,
Exactly, that’s the thing. Of course i can rearrange the faders…
The thing is: my standard set up was 22ch + 22mon-splits (from IP23to44)… we had a tour and in between the Tour there were some changes (especially some mon-channels were not needed so that i could use them for support bands etc..)
rearranging over the strip-assign worked fine on the tour.
now i’m one week before the next tour starts and we puttet the changings in the new rider… and my plan was to “clean-up” my setup.
I’ve got 48 channels full on work so it can (with a little bit of time-stress) be very annoying if you have to search for your channels (even in the strip assign-menu)…
but anyway thanks a lot!!!!
Thanks for the answer!!
i thought so too, but it changes the input socket, not the ip )-: (as i said perhaps my brain is totally blocked and i’m only too stupid)
for example I’ve got
GIT on IP-3 …
i set up the input socket AR24/12 NR 3 (in the I/O setup) to use the IP-3 …
now i want to move the whole channel including all settings (Aux etc) to
IP-4 and Input Socket AR24/12 NR 4 (so that i have my order nice and sortet even in the channel-strip-setup and IP-3 aswell as Input Socket-3 is free for new settings)
by changing it in the preamp page to nr 4 I’m just telling the channel with IP-3 to use the Input-Socket 4 means just another preamp but still for IP-3.
I guess the only way would be using the desk with the copy function….
Any Ideas??
Thanks again for your help! And sorry for my bad english (-;