Forum Replies Created

Viewing 4 posts - 406 through 409 (of 409 total)
  • Author
    Posts
  • #24579
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Kristian,

    1. Yes it is possible to fit RAB2 to any iLive surface, just not ilive T-Series surfaces.

    2. Yes the RAB2 module has built in headphone amplifier, two card slots and optional DARS + Wordclock in/out connectors (BNC Connections)
    NOTE: D.A.R.S + WordClock on the surface RAB2 will only work if you have a valid active audio link between Mixrack and surface.

    D.A.R.S = Digital Audio Reference Signal – or AES11-2003 signal is AES3-formatted audio signal capable of being referenced, locked and distributed at the same audio frame rate of the iLive system 48KHz.

    Hope this help
    Sam A&H

    #24575
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Wolfgang,

    I have been unable to recreate your issue. would your be able to send the show in question to: Support@allen-heath.com

    Can you also provide a description of what parameters are incorrect when you recall the show on your desk? Also a description of your offline show hardware and your physical hardware setup.

    Does the offline setup in Editor match the physical hardware setup you have? It is important that the offline session does match your physical system setup so that you do not have any compatibility issues that could cause parameters to be different.

    Best Regards
    Sam A&H

    #24540
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Lieven

    With regards to ACE

    The traffic lights in the Surface Link info window on the Status page show QOS – Quality of service of the connection between MixRack and Surface.

    Green means no packet errors have been recorded in the last 3 Minutes
    Orange means 1 -> 2 errors have been recorded in the last 3 minutes
    Red means 3 or more errors have been recorded in the last 3 minutes

    This is a rolling window of 3 minutes, meaning that errors drop-out of the calculation after 3 minutes have past.

    Examples
    A 3 error cluster will turn the traffic lights to Red; this will then return to green after 3 minutes if no further errors are found.

    If you have 1 error every 50 seconds continuously this will result in the light going red and will stay in the red.

    2 quick errors then 1 error within 3 minutes will result in the traffic light going red briefly, then to orange (as the first two errors drop out of the window 3 minute window), then back to green 3 minutes after the last error.

    With regards to cabling

    If you are getting regular errors it is a good idea to check your cable quality and make sure that the Ethercon connections on the iLive system are clean and in good condition.

    Your cable length seems fine but I am unsure of the quality of the cable you are using. Below is a link to the recommended/Tested cable we supply at A&H.

    http://www.ilive-digital.com/Downloads/Understanding_ACE_rev_11AUG09.pdf

    Hope this helps

    Best Regards
    Sam A&H

    #24525
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Peter

    I just tried E-mailing you to try and get some information to help you with your issue you are having. can you please let me know if you recieved the E-mail i sent you so that i can try and help you resolve your issue as soon as possible.

    Regards

    Sam
    A&H

Viewing 4 posts - 406 through 409 (of 409 total)