I am trying to do a similar setup. However, I have 3 DX168s, a gigabit network switch, and a SQ6. I would like to connect all 3 DX168s to the network switch, but it sounds like that is not possible?
Why can’t I do a setup mentioned on page 7 here with a switch rather than a DX hub? https://www.allen-heath.com/media/SLinkConnections_V1_5_0.pdf
I have tried this setup with 1 DX168 and all cat6 runs, but my SQ6 seems to negotiate/recognize gigaACE/gigabit and does not recognize the DX168 that is plugged in. When I downgrade the cable or run directly to the DX168, it shows the DX protocol and everything works.
Would it be sufficient to run a network switch with 1 gigabit and four 100 megabit ports? This would force the 4 ports to DX protocol/100megabit speed and force the gigabit/gigaACE connection to the SQ6?
Let me know if that sounds right or if you think that workflow will work.