[RocketmanParticipant]

Everything on the board is set prefader… are referring to just the guitar channels FX sends? I will say that I don’t run any FX’s on either guitar from the mixer. Could you explain a bit more… this could be my problem…

[RocketmanParticipant]

I will try that this weekend if it does it. I had another odd thing happen last night. On the LR mix I turned my guitar slider all the way off and was the getting sound from my guitar through the main speakers… my monitor mix was muted. Correct me if I’m wrong but shouldn’t that have turned my guitar off in the main speakers?

[RocketmanParticipant]

Thank you, very helpful

[RocketmanParticipant]

Also we use IEM and the guys told me last night they could hear it in there IEM mixes…

[RocketmanParticipant]

Well I never found out what the cause is. Some nights it does it and some nights it doesn’t. Last night it was doing it… sounded like everything was in a can and I had a slight phaser effect on everything… I turned off all the vocal compressors, and effects… but it’s not just on vocals it’s on the instruments also… its crazy idk… when it does it the next time I’m going to try and do a hard reset and start from scratch to see if that gets rid of it… I wondering if it Maybe the electricity its drawing from the wall outlets… we play in alot of these old clubs where the wiring has 2 or 3 different grounds and hasn’t been updated in 20yrs…I appreciate the input and all the help…

Thank u,
Rocky

[RocketmanParticipant]

I am going to try some of your guys suggestion this coming weekend and will give everyone and update… thanks so much for all the feedback and suggestions…

[RocketmanParticipant]

I turned the effects off via each person’s effect return…

the drummer uses a roland module, and my self and the other guitarist run Fractal axe 3 and fractal Ax8… no other outboard equipment…

I never tried to see if I could hear it via headphones through the PFL…

My drummer plugs his headphones in his roland module and we send him monitor mix via aux send1, and he has heard it… it doesn’t do it all the time..

[RocketmanParticipant]

I have the same problem… I set my input gain per channels as you said to “0” dB. But there are some channels such as drums and bass that the signals are to hot and I can’t get them to 0db without clipping…I also try to run my outputs at unity gains when possible.. last night I unplugged the Me1 and connected to my monitor output out to my Shure psm900 IEM and recieve that signal and it was much louder and very useable… I haven’t changed any of the main outputs signal path. They are all set as it comes from the factory. I haven’t had the QU mixer a year. but the main mix out FOH is Awesome…Not sure what else to do other than just use my monitor send directly from the and not use the ME1…

[Author]

Posts