Forum Replies Created
-
AuthorPosts
-
2021/04/29 at 9:50 am #100994
Hi there, do you think if will be possible an integration with Sennheiser RF devices like the integrating Shure RF ? thank’s
2010/08/30 at 4:49 pm #26243quote:
Originally posted by peterHi there
I have a ILIVE 144 + IDR10 plus a T112+ IDR 16. Both IDRs have the MADI card, so I can use that like monitors/FOH desk. I record by a PC with NUENDO and a RME pci card inside. The system working very well. The only problem is thai I don’t have a long (100 m) double video cable, so I am forced to place the PC close the IDRs on stage. The question is: If I buy a DIGIGRAM LX6464 (Ethersound PCI Card)can I connect directly to ILIVE 144 surface ethersound Port B, by way I can control the PC by myself in FOH place?Thank’ a lot to everybody. I forgot that the magic machine(ILIVE) get a wonderful network system, and I set a second PC (laptop) at FOH with VNC software, and it works perfectly. Thank you gentlemen.
2010/02/26 at 6:38 pm #25230Thank you jeff
You are right.The problem is an hardware bad conctat. May be on RAB2 module or on MADI card itself. I tried to tighten screws for ending set up and suddendly the MADI connection stop working.So just open the screws a little bit an it returns to work. So I am in contact with local vendor for a spare or a tecnhical overview. However, for a while I tested the system and I find it very powerfull,especially for the virtual sound check way. This is a wonderful tool for sound engineers.Thanks a lot.2010/02/26 at 11:40 am #25228Hi Jeff
It works finally. Was not problems of software, or firmware or something else. I just tried to unplug the card from RAB2 module, and carefully plug it again, and like a miracle it was going working, either in input and output. So I think was a ploblem about pins conctat, also I cared very much for insert. Thank you very much and I hope that experience can help everybody for all those will have same issues.2010/02/25 at 7:06 pm #25226Thank you Jeff.I tried to set the madi card either in link1 and link2 separate and redundant. But It seems not work. The message on the screen are: Link1 signal green flag;link2 signal green flag. But Link1 lock,Link1 error symbol,Link2 lock,Link2 error symbol are red crossed.What’s the meaning???I tried to loop output with input with i.e. a cd player on IDR MIX channel 19 & 20, and read it from MADI 19 & 20 sets on an other strip . But I have not signal.May be it is damaged!!!
Tomorrow I’ll try to follow your indication for a signal generator applied. If I’ll have not positive result, next week I’ll contact the local distributor for a spare. Thanks again2008/09/26 at 9:55 am #24075Thanks so much Frank,
I missed the step of set my surface on external control.I did’nt find it nowhere.
Now it works succesfull.
Peter -
AuthorPosts