[odesrParticipant]

I use a seagate USB drive. First use, all was OK. Second use (some weeeks later): not recognized. ?? I tried many things (e.g. rebooting my QU16, formatting the drive on a PC, etc.), and nothing worked. The same day I tried 3 different USB keys, and none of them were recognized.

However, I have a bad habit: I directly switch off or reboot my Qu16 by pressing the button behind the mixer, without using the “shutdown” menu. So, I tried a “soft” reboot using the recommended method. And then… my drive was recognized, as all the usb keys I had tested before.

A story that may be useful to some Qu users who face difficulties with their USB devices…

[odesrParticipant]

Many thanks for your answers.

[odesrParticipant]

mmm. OK. For the L/R mix, Fx are set to post-faders. Certainly not a big deal to make this optional for the Mix. May be in 1.6…

[odesrParticipant]

Thank you very much Dan. You fixed a lot of my problems. First my FX2 channels were set on post-fader. Second I didn’t unassigned the Fx2 return from the LR mix. Now it works almost like I want to. I have a reverb mix for the mix1-10 and another for the LR mix.
Last trouble. On a given mix – say mix 1, I can hear two signals : the wet and the dry. If I put the channel fader down, I do not hear the dry anymore, but I continue to hear the wet. Is this what you meant by :

when Bill asks for reverb in his monitor, and Jane wants reverb in her monitor too, the reverb will contain all the vocals that are “sent” to this common FX2 reverb

In any case, thanks again!

[odesrParticipant]

Yes the returns are up. And still no reverb in the mix… (edit: yes I can hear the dry sound of the LR that returns in the mix but 1) it’s vey low and 2) it’s dependent of the LR mis, and U don’t want to).

[odesrParticipant]

Thank you for your answer. Yes the Fx2 is going to the main mix (LR). But I don’t want to. I want it to go to the mix1-10 only. Yes the mix group sends are set to Pre-fade.

[Author]

Posts