Ok, after experimenting a bit with this, I can see that the only missing feature is selection of which PAFL bus you’d like to use, and a PAFL button on the strips in OneMix. If that were added, it would be great! It’s already there in MixPad so it should be easy enough.

+1

Are the Scott Dixon cases the only ones for the c1500 that get the weight under 32kg?

Are there any other choices, perhaps something available in the USA or Canada?

I have used it, but not extensively. I will continue to work with it to see how I can do what I need to do.

What I have noticed is that in demo mode faders and mutes and other controls are static. Create a mix and then switch mixes and the faders don’t move. MixPad only seems to work properly when it’s connected to a Mix Rack.

Is there mix on/off control per channel/per mix on the iPad app? I don’t want to use a fader – I like to verify that mixes are the same volume as well as tone when checking.

@ Mr.X: you can route the oscillator to a input channel you then can control from the iPad. Although it is not as easy/convenient as on the Yamaha Stagemix, it is still a great way to do System checks. At least it works for me….

Good idea. So send that channel to all mixes and then mute/unmute each mix master?

Thank you for the update, Nicola!

Fully Agree. The iOS developers should take a look at the competition’s offerings and add some critical missing features.

MixPad improvements

Your MBP is set to a fixed IP of 192.168.1.60. Go in and change it to DHCP or whatever the “automatic” settings are for a Mac…

Director’s Fine, but when I’m out on stage patching and checking lines, I like to be able to name channels. iPad is best for mobility.

you can name in the Director in the text input field, then press Enter.

then press TAB to automatically jump to the next channel.
you do not have to leave the name entry mask.

But it took me two years until I found that out by chance 😉

Is this possible in MixPad? With other iPad mixing apps, I’m constantly re-naming channels using the iPad and…[Read more]

So using the VSC settings wouldn’t work?

What about using the Virtual Soundcheck settings for your tracking?

Never mind. I see you have to do it from the PreAmp page, it’s not part of IO page for some reason…

How do I patch the PAFL output to an input channel in Director?

I see MixRack Input Sockets (Local/DX/IO) for possible inputs to each channel, but I don’t see PAFL outputs as possible inputs.

In the 1.70 video seminar, it shows that this is possible, but I can’t see how it’s done.

I wasn’t expecting either. Just reporting on what I’ve found.

I’ve been told from the distributor that the DX-164W will not be available until next year – it’s being redesigned?
Can anyone from A&H comment?

Ok, so it’s confirmed. Director sends MIDI messages but doesn’t respond to them.

I had read that if you install a GigaACE card in the CDM rack and one in a C-series surface, you can run a redundant connection between the two.