[MaximusParticipant]

Thank you for the suggestion Mike, I did that earlier today (granted I wasn’t using static or white noise) and I was getting line level on both ends of the cable.

[MaximusParticipant]

The cable goes straight from the computer into the board. As far as I know there’s no compression on the signal, however we do have the built in gate on it. We put the EQ from the board on the channel as well. I ran signal through the cable on a different channel and had the same overall amount of signal going through both sides of the cable. I would’ve taken a picture of the cable routing, but it’s a bit of a mess behind the board and live streaming setup.

[MaximusParticipant]

Here’s a YouTube link. Apparently a 10 second video is too big to upload here.

[MaximusParticipant]

I’ll have to check the cable in a mono input after service (it’s almost like people want to hear what’s going on). I’m monitoring the level from the processing screen on the board, in addition to it being an audible change in the speakers as well. I took a short video showing the difference, and the cable we have is the RCA one with 1/4″ adapters.

[MaximusParticipant]

The cable is an 1/8″ splitting into 2 1/4″ and I don’t think it’s the cable because we flipped the inputs each of the 1/4 were plugged into and still had the same problem. In addition I plugged them into one of the other sets of stereo channels and had the exact same problem. I can’t double check any of these things until Sunday when we’re back in the building, but I’ll bring an addition 1/8 to 2 1/4 that I have with my stuff to make sure it’s not the cable. And we’re just taking it from the computer directly into the board, no direct box or interface.

[Author]

Posts