Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #97929
    Profile photo of syber_jedi
    syber_jedi
    Participant

    +1

    #91472
    Profile photo of syber_jedi
    syber_jedi
    Participant

    Bump. 😀

    But seriously, we were able to acquire an IP8 and can find other uses, but I still would love to be able to use it as a dedicated controller for adjusting a mix to our broadcast matrix out.

    #88615
    Profile photo of syber_jedi
    syber_jedi
    Participant

    Myself and a local friend who also uses dLive have been having this issue. My friend, who is further along the support chain then I is in the process of hard factory resetting the mixrack, and then starting with a new show file from scratch. My best guess is there is some corruption in the show file established during one of the 1.8 updates.
    I’m prepping to start from scratch with ours as I work with support on the issue.

    #87383
    Profile photo of syber_jedi
    syber_jedi
    Participant

    MIDI faders would be AWESOME.

    #87351
    Profile photo of syber_jedi
    syber_jedi
    Participant

    +1

    #87294
    Profile photo of syber_jedi
    syber_jedi
    Participant

    I was about to purchase an IP8 for the ability to use it as a mix control. We have a broadcast mix where a bunch of groups, and a few inputs, are run to a matrix mix. It was only last night that I sat down and tried to program it, only to realize it’s not going to do what I need it to. Very disappointing. I can’t justify the cost until this feature has been added. :-/

    What I imagined was either that a set of faders could be set to control to a pre-determined mix, or that I would hit a softkey on the IP8 and all the faders would become “sends on fader”

    #84652
    Profile photo of syber_jedi
    syber_jedi
    Participant

    +1
    😉

Viewing 7 posts - 1 through 7 (of 7 total)