Forum Replies Created
Viewing 8 posts - 1 through 8 (of 8 total)
Viewing 8 posts - 1 through 8 (of 8 total)
I agree that losing the store confirmation is a bit dangerous. The other thing I noticed is that the right screen blinks when you recall a scene…minor annoyance.
I asked the same thing about 2 weeks ago. Hold the setup button while you’re in scenes.
I’m using a RaspberryPI with Android installed on it. It has usb for a BCF2000 and a hard wired Ethernet port. I needed a fader pack for my QU-PAC for an event.
I just went through a similar upgrade process. I went from QSC k series to Meyer. I got UPQ-1P’s. They are major overkill for most of my gigs now, but I don’t regret the purchase. I did purchase UPJ-1p’s for the smaller gigs and they are fantastic.
I’m having a similar problem. Haven’t had the chance to upgrade to 1.22 yet because of show schedule.
The screen will lock while I am dropping channels into faders. I’ve had this happen 3 times in the last week and a half. One of the times I did notice that changing fader layers on bank two became sluggish.
GLD 80
AR2412
AR84
Here’s another question…
Is there any way to use a switch to change the order of the devices on dSnake. I’d like to run the console to a switch, then split that to go to the AR2412 and a AR84. My problem is that I need both AR84 local (within 40′ of console) and the AR2412 about 200′ away. I’d rather not have to string two 200′ cat5, one to the AR2412 and one back to the AR84.
Is it possible to use a switch to do this?
GLD 80
AR2412
AR84
That didn’t seem to work last night. The new channel grabbed the input socket, but the replaced the original channel with something else. Looked like a montor socket.
GLD 80
AR2412
AR84
I’m disappointed with the A&H case. The case that was shown on the Facebook page is NOT the case that A&H are shipping. The case that I received has no nose cone, no 1U rack under the console, does not hold the board captive while the lid is off and is just on the tray, and has a paper thin plastic lining on the outside. I’m already seeing wood on the side of the case where the laminate has come off. If it got this damaged during transit from A&H to me while in a cardboard box and shrink wrap, it’s not going to last a single trip in my trailer without looking like one of my 20 year old Anvils.
I would not recommend this case and will be returning it and having a custom case built.
I’d appreciate a comment from someone at A&H.
GLD 80
AR2412
AR84