[jamfactoryParticipant]

1. You have an IP address conflict. Also the ilive T112 doesn’t like it when you put cat5 cables into the network and route it everywhere like ‘the internet’ (although I’m not clear on what you mean by that). With all A & H gear the ‘KISS’ principle is best. Follow the signal flow and there should be no issues. That said, it’s likely that the idr48 is seeing a conflict of where you’ve connected the network cables. Basically, start again. Unplug all network and ACE cabling and eliminate which one is giving you the trouble. Also I’d say it sounds like you have a sh!t ACE cable. Get a different Cat6 cable and compare the results.
Widen the range of ip address between the two so they don’t conflict with each other.

2. Plate vox for most situations, especially indoors. For large arena or wide open spaces you may need to use less tight and more wet fx like large hall etc. But it’s very much a personal preference thing.

Good luck!

[jamfactoryParticipant]

Yes. Correct.

I’ve sent in Event Logs to A & H and they requested I try to create a cable/socket wobble type scenario. But I’ve not been able to get the symptom to repeat itself now.

Un-nerving as it could happen randomly in a show.

Thank you for your help. 🙂

[jamfactoryParticipant]

Thank you for your reply. 🙂

T112 connects via Dsnake-grade cable to network wall socket at FOH control booth point, permanently installed by building contractors (presumably Cat 6 but uncertain. Reno is only 8 months old).

Comes out socket of same on OP side of stage. However, as part of diagnostic process of elimination I have changed that now to direct from the socket to the IDR 64.

Rack also has 5 dual UR4D SHURE units in the network. Only other network member is Meyer Galileo controller unit. That’s mostly it.

Fairly simple set up.

[jamfactoryParticipant]

I’d say it’s disconnecting from the MixRack – as in losing the connection.

I’m looking for a solution for that, hence I stumbled across your post. If I get any answers out of Allen & Heath and don’t get fobbed off I’ll let you know.

[Author]

Posts