Forum Replies Created
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
Hi Folks
Upgrading to V1.22 seems to have done the trick. We ran a 2 hour show yesterday with out an error/freezing from the GLD80.
However. After upgrading we did get a few errors and auto-reboots, in the USBManager.cpp file. Inserting a memory stick in the USB seemed to solve that. We have a matrix mix sent to the USB recorder, Im guessing there’s still an issue with checking if a memory stick is present. Will investigate further.
Hope everyone’s GLD80 working ok with v 1.22.
All the best
Derek Baker
GLD80 / AR2412 / 2 X AR84
Hi Folks
I’ve had the same problem. Our GLD80 starting generating lots of log messages, then afterwhile locked-up, had to hard reset. This then happened again.
We had a Matrix mix sent to the internal USB recorder, but did not have a USB memory stick plugged in. We removed the mix on the patchbay i/o screen and issue ‘seems’ to have gone away.
Snippet from our logfiles:
Thu Jul 25 21:07:27 2013 :: /dev/ah_usb_dsp – Flush failed (../../iGL/trunk/Common/Audio/USBManager.cpp:278)
Thu Jul 25 21:07:27 2013 :: Bad conversion to boolean for UBYTE with value 0xb (../../AES-Standards/Convert.cpp:25)
Thu Jul 25 21:07:27 2013 :: Flush failed, /dev/ah_usb_dsp, No such device (../../iGL/trunk/Common/Audio/USBManager.cpp:309)
Thu Jul 25 21:07:27 2013 :: Flush failed, /dev/ah_usb_dsp, No such device (../../iGL/trunk/Common/Audio/USBManager.cpp:309)
Thu Jul 25 21:07:27 2013 :: Flush failed, /dev/ah_usb_dsp, No such device (../../iGL/trunk/Common/Audio/USBManager.cpp:309)
Thu Jul 25 21:07:27 2013 :: /dev/ah_usb_dsp – Flush failed (../../iGL/trunk/Common/Audio/USBManager.cpp:191)
Thu Jul 25 21:07:27 2013 :: /dev/ah_usb_dsp – Flush failed (../../iGL/trunk/Common/Audio/USBManager.cpp:191)
Where’s the A&H ticket support URL?
We’re on firmware v 1.2.0.
Have a wedding and church service to engineer this weekend, hoping GLD does not freeze!
Derek Baker
GLD80 / AR2412 / 2 X AR84