[beartechParticipant]

Thanks again Chris. It seems that I will need to use DCA’s and Groups to reach my goal. This is disappointing and may be confusing to less experienced tech’s. I wish there was a better option. Its a shame I cant route inputs to the FX and dump the output to a group. It seems that all the outputs on the FX modules are fixed to return to the same source that came from. (no way to cross patch). Alternately it seems I should be able to select using the mix key, where the FX out goes (mains or not, Aux or not, etc) This may be a place to request an improvement in the firmware.

David

[beartechParticipant]

Good input Chris. I did create groups to mimic the analog behavior, but this created a new problem. With groups, all the inputs are routed to individual group, but the FX for each input are routed directly to the FX rack and back out to the mains. So if I mute a group, I still have the FX sound going to the mains. Do I have to route the whole group to the FX? What if there is something in that group that I don’t want reverb on? Or if I want reverb on inputs that in different groups?

David

[beartechParticipant]

For what it’s worth, I solved this problem the same way. (using an Aux send)

[beartechParticipant]

I’m in a similar situation as Eastonpromise. I have a GLD-112 that I have been using for a few months and have been running DCA’s for Instruments, Drums, Vocals (similar to the Sub Groups on my old Analog board). The problem is that when I PFL the DCA, I get PRE-fader levels on all audio. I tried sending the desired vocals into a Mono Aux, but couldn’t find a way to dump them back into the LR Main mix. Maybe I should have tried stereo mix? Or is there another option?

[Author]

Posts