WZ16 2DX faders not working

Forums Forums Other A&H products WZ16 2DX faders not working

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Rob Red Rob Red 1 year, 6 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #109039
    Profile photo of Rob Red
    Rob Red
    Participant

    Hi
    I have a WZ16 2DX desk to use in a small recording/ rehearsal setup. I have ewver used an A&H desk before!
    My problem is, none of the faders are working. There is gain control on each channel, and on aux 1, but nothing happening with the faders.
    Setup is as follows
    laptop DAW via Scarlett 2i2 interface. output on 2i2 plugged to desk input on channel 1.
    mic input to channel 2.
    Main stereo out from desk to line inputs on 2i2
    Room PA is fed from Aux 1 output
    I don’t know what I am missing, but I cant get faders to do anything……Any ideas please???
    Rob Red

    #109043
    Profile photo of Mike C
    Mike C
    Participant

    Aux 1 and 2 are pre fade auxes on a Mix Wiz, the channel fader will not control those levels.

    Aux 5 and 6 are post fade auxes, those would be controlled with the channel fader.

    #109048
    Profile photo of Rob Red
    Rob Red
    Participant

    Thanks for that Mike, I will give that a go tomorrow

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.