User "Basic" Issues

[MarkusParticipant]

HI all,

i run a Qu16 in a live Club. From mix 9/10 i feed the bar area upstairs. A PC plays bar music on ST1. This is meant to play in both places during non- live opening hours, the barman needs to set the volumes to his Needs himself.

When i log into the Basic user, the desk loads the scene i created and all is good….. BUT: the desk starts with LR selectd, not in MIX 9/10 layer and the Basic user seems not to be allowed to change the selection… can i change this behaviour so that the desk starts in layer 9/10?
Is this because i saved the scene when the selected Output was LR not 9/10?

Thanks Markus

[[XAP]BobParticipant]

Don’t know, but you could use alt-out, or a split feed and just have a control on an amp upstairs?

[jet1968Participant]

don’t think you can save the scene to recall on any particular layer, you might be best using the custom layer if you want restricted access

[MarkusParticipant]

thanks for your replies- i will go and check it out….

[Author]

Posts