Use soft keys to change effects preset

Forums › Forums › Qu Forums › Qu feature suggestions › Use soft keys to change effects preset

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of eotsskleet eotsskleet 10 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2014/04/05 at 4:24 pm #38753
    Profile photo of Ron
    Ron
    Participant

    I wish you could assign soft keys to change effects preset.

    Would be nice to switch from a large hall to small room with the push of one button!

    Ron

    2014/04/05 at 5:58 pm #38757
    Profile photo of eotsskleet
    eotsskleet
    Participant

    i think this should work by using 2scenes with recall-filters! Maybe you just can set the global filter to “Block everything except FX Parameters” or another solution may be a scene where you safe everything except the FX Return! Probably the Send-Level will change with the scene!

    2014/04/05 at 6:14 pm #38758
    Profile photo of Ron
    Ron
    Participant

    That would work.

    Although I can see myself changing the whole board right in the middle of a song, pops in sys from phantom power going on or off!

    Will have to experiment.

    I still think the soft keys should do this.

    2014/04/05 at 6:17 pm #38759
    Profile photo of eotsskleet
    eotsskleet
    Participant

    Well i think if you just want to change the FX that should work without any pops! I use scene a lot during shows and never experienced problems.. well yes you have to check that first if it does work for your changes!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.