TCP/IP MIDI protocol and "reading" mix state

Forums › Forums › iLive Forums › iLive general discussions › TCP/IP MIDI protocol and "reading" mix state

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Laughing Kitten Laughing Kitten 7 years, 9 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2016/07/14 at 8:21 pm #57169
    Profile photo of Laughing Kitten
    Laughing Kitten
    Participant

    The iLive TCP/IP control protocol (v1.9) provides for sending of commands from AMX/Crestron or other like controllers. However, there is no way for the such controllers to read back the state of the iLive or to receive notification that a scene has been recalled changing the control parameters.

    The Qu-series control protocol resolves this by providing a feed to controllers that request it.

    Is there a similar mechanism for iLive? Or, is there some other mechanism for accomplishing the same goal?

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.