Surface Strip Layout feature

Forums › Forums › dLive Forums › dLive feature suggestions › Surface Strip Layout feature

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2024/08/29 at 12:40 pm #125105
    Profile photo of Bob BriessinckBob Briessinck
    Participant

    When using an action to recall a strip layout it stays at the layer it was on before the recall. If I use this function to replace the DCA spill workaround (which would end up in unorganised layouts) I have to go to layer A manually. Being able to default it to layer A (or any layer of your choosing) would be nice.

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.