SQ6 to DAW via tie lines & Dante

[Welcomemattvo]

Hi there, apologies if this has been discussed before but I did a search and couldn’t find the answer.

We currently route signals from both the AR2412 and local XLR inputs to Logic Pro using tie lines and Dante, in order to make a separate mix for our church livestream. My question is, if one of the inputs isn’t also assigned to a channel on the SQ6 (because it isn’t required FOH), how is the gain controlled before it hits Logic via Dante Virtual Soundcard?

[Anonymous]

Easiest thing to do is to drop the channel onto a slot/layer on the surface, select it, make any changes you want to gain or otherwise, and then swipe it off the slot/layer again if you don’t want it visible to the board operator.

[KeithJ A&H]

Socket control is available in the I/O screen.
Touch the input socket to get preamp control (where available) without requiring the socket to be patched to an input channel.

Hope this helps!
Keith.

[Welcomemattvo]

Nice! I’d no idea you could do that! Thanks Keith.

[Author]

Posts