SQ5 Home-brew Table Using Gator ATA Case as Base

Forums Forums SQ Forums SQ general discussions SQ5 Home-brew Table Using Gator ATA Case as Base

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of KenM KenM 5 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #82639
    Profile photo of KenM
    KenM
    Participant

    Hi, I had some used 1/2″ 10-ply (very nice plywood) that I made into a table top using the Gator ATA case as a base. The Gator case is a very stable base. Now I don’t have to stash my case at a gig, it stays right under the mixer. I opted for 30″x19″ table.

    The height was just right. This is my small gig setup. I can setup anywhere in the room quickly. The headphone peg is a 1/4″x4″ bolt that slides out when needed. The 1/4″ plywood strips on the bottom are there because the handle was a bit taller than the corners of the case. I like using an apple box as a seat. It serves multiple purposes.

    Attachments:
    You must be logged in to view attached files.
    #82644
    Profile photo of KenM
    KenM
    Participant

    Here is a side profile. I cantilevered the top for leg room. Still very stable.

    Attachments:
    You must be logged in to view attached files.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.