SQ5 Group Issue

Forums Forums SQ Forums SQ troubleshooting SQ5 Group Issue

Tagged: ,

This topic contains 4 replies, has 2 voices, and was last updated by Profile photo of Gil Gil 1 week, 3 days ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #107700
    Profile photo of Gil
    Gil
    Participant

    I am new to mixing and the SQ5 and I can use some help.

    Setup:

    Two microphones plugged into A&H AB168 which connects to the SQ5.
    The two mics are not assigned to the LR or any other mix.
    The two mics are the only inputs to a single mono group.

    Desired Operation:
    I want to be able to use the fader to remove all sound from the group across the LR and all mixes without having to mute the group.

    Problem:
    When I slide the fader for the group all the way down I still hear low input from the microphones. Why? I would have expected the volume to be 0.

    I would appreciate any help in solving this issue.

    #107701
    Profile photo of Gil
    Gil
    Participant

    I should add that the group is set to Post for LR and all mixes.

    #107710
    Profile photo of ioTon
    ioTon
    Participant

    Hi Gil,
    And when you Mute the group, the volume of the mic’s is 0 ?

    Or when you mute the Input channels – the the volume is 0 ?

    greetings,
    dd

    #107719
    Profile photo of Gil
    Gil
    Participant

    If I mute the group LR is muted. If I take the fader all the way down, LR has no volume. Muting does not fully mute the other mixes. Taking the fader all the way down does not fully cut the volume on the mixes.

    #107737
    Profile photo of Gil
    Gil
    Participant

    Problem solved. I had left the reverb effect on both mic channels instead of the group. Once I removed the reverb from the individual channels and put it on the group all worked as expected.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.