SQ5 automatic Startup

Forums Forums SQ Forums SQ general discussions SQ5 automatic Startup

This topic contains 8 replies, has 6 voices, and was last updated by Profile photo of SteffenR SteffenR 9 months ago.

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #104342
    Profile photo of fisch
    fisch
    Participant

    Hello guys

    it is possible that the SQ5 during startup loads automatically (without any user interaction) an saved scene.
    target is to have after every startup the same default configuration loaded.

    is there somehow an posibility to do that?

    thanks

    Best Regards

    #104344
    Profile photo of MarkPAman
    MarkPAman
    Participant

    Yes

    See page 89, and the top of page 90 for user settings.

    #104363
    Profile photo of Vali
    Vali
    Participant

    @markpaman , seems to be pages 91 -> 92
    pages

    #104364
    Profile photo of Vali
    Vali
    Participant

    Image link in below post seems not working, so I’ve uploaded here

    Attachments:
    You must be logged in to view attached files.
    #106202
    Profile photo of fisch
    fisch
    Participant

    hello all
    thanks for reply.
    unfortunatelly there is a manual action needed (active login)
    the SQ5 is placed in a technical room and can be switched on via a special switch in the gym from the trainer with a key.
    it would be great if after booting the console login a certain user and load the linked default scene without any interaction on the SQ5 itself.

    thanks a lot

    #106207
    Profile photo of Scott
    Scott
    Participant

    Create a user on the SQ that has no password. Log in with that user just prior to shutting down, and the mixer will come back to that user on the next power on cycle without prompting for a PW since there isn’t one.

    #106629
    Profile photo of fisch
    fisch
    Participant

    Hi Scott
    thanks that work.
    is it also possible to load directly (without any interaction) an certain configuration/scene?

    thanks in advance

    #113447
    Profile photo of Hrish
    Hrish
    Participant

    Hi,

    I was looking for more information on this topic.
    We too would need it to load a scene on startup without needing the confirmation setting

    Is it possible?

    Thanks in advance!

    #113448
    Profile photo of SteffenR
    SteffenR
    Participant

    As already described above, set a user with no password and set a startup scene for that user.
    Make sure the scene confirmations are set to off. Setup > Surface > Preferences

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.