SQ5 1.5 USB-C out to USB-B USB No Audio

Forums › Forums › SQ Forums › SQ troubleshooting › SQ5 1.5 USB-C out to USB-B USB No Audio

Tagged: 

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of Flo84 Flo84 3 years, 11 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2020/05/15 at 11:01 pm #91867
    Profile photo of Gadgetguitar
    Gadgetguitar
    Participant

    I am on my 2nd SQ board. 1st one had a pad pixel and only had it for a couple days. Received the new one today, updated the firmware, plugged in the USB-B cable from my iMac. I am using the USB out, which is set to the In1/2. The previous board fired audio out of iTunes after I set the SQ out for audio out. Doing the exact same thing and nothing playing through this board. I did hard reset the board.

    2020/05/16 at 7:38 am #91870
    Profile photo of Flo84
    Flo84
    Participant

    Hi,
    check if usb source on your Sq is on “USB-b”.
    Since 1.5 the selection between USB-b and sq-drive mode has been moved from I/O page to setup (page where you can also choose between 96 or 48 KHz).

    2020/05/16 at 1:40 pm #91880
    Profile photo of Gadgetguitar
    Gadgetguitar
    Participant

    This was the problem. I guess I did change it on the other board and forgot. Thanks!

    2020/05/16 at 8:14 pm #91886
    Profile photo of Flo84
    Flo84
    Participant

    Happy to hear I could help 😉

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.