Sq to GLD dante card popping problem

Forums Forums SQ Forums SQ troubleshooting Sq to GLD dante card popping problem

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of Tom Tom 2 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #102563
    Profile photo of Tom
    Tom
    Participant

    Hi,
    i connect my gld 112 with dante card ( firmware 4.0.3.8) to my sq6 dante (firmware 1.0.5).

    I have always digital clipping. I try 3 cable cat 6 but the result is the same. I try all latency setting in dante controller but nothing. The signal is present but sometimes i hear “tik tik” during sound and sometimes during silence.

    This problem are the same in sq to gld direction.

    Does anyone have any suggestions for resolution

    Thanks all,
    Thomas

    #102564
    Profile photo of Tom
    Tom
    Participant

    Sorry,
    I found now that the audio sync on gld was set to internal and sq on i / o card. Now I have also set GLD on slave option card and now it seems to have no problems, I update you on the problem.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.