SQ Remote App & Q-Sys Networking

Forums › Forums › SQ Forums › SQ general discussions › SQ Remote App & Q-Sys Networking

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Phill Phill 5 years, 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2018/06/15 at 1:55 pm #71863
    Profile photo of DSchanck
    DSchanck
    Participant

    I am looking at installing an SQ-5 as my primary console and using a QSC Core 110f as my signal processor to route some pieces that don’t need the complexity of my full console and would be utilized by end users who would just be confused by the console.

    Is it possible to run the SQ control app and Q-Sys control interfaces through the same private network? Both devices would have independent IP addresses but would be connecting to the same Wireless Access point that would act as their router as well.

    2018/06/15 at 10:57 pm #71871
    Profile photo of Phill
    Phill
    Participant

    I can’t see why there would be any issues….

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.