SQ-6 and AR2412

Forums Forums SQ Forums SQ general discussions SQ-6 and AR2412

This topic contains 4 replies, has 3 voices, and was last updated by Profile photo of Gary Gary 5 years, 7 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #73503
    Profile photo of Gary
    Gary
    Participant

    Hey,

    Is there a special boot up order or additional setup required to make the SQ-6 see the AR2412? I’m using a CAT6 cable and have tried many other CAT5/CAT5e cables and they won’t see each other.

    Thanks in advance,

    #73504
    Profile photo of Gary
    Gary
    Participant

    Will a UTP CAT5/CAT6 cable work at all, or is an STP cable required?

    #73506
    Profile photo of GCumbee
    GCumbee
    Participant

    I have as yet connected a 2412 to a SQ. But have sold systems that have and they worked fine. I’m getting ready to do an install soon with SQ6, 2412 and 168. I have done many QU and GLD. No problems. I’m wondering if you have a problem 2412. Or even SQ.

    As for cable. I’ve used various cables 5 & 6. I usually use 6 shielded for installs. Haven’t had any issues even pushing limits on distance.

    #73510
    Profile photo of Bob
    Bob
    Participant

    Hi Gary:

    I have both the AB168 and the AR2412 and have used both successfully with various lengths of shielded and unshielded Cat5/6 cable.

    Since your post, I tried various power-up sequences and it did not matter … the SQ readily recognized the remote boxes.

    #73512
    Profile photo of Gary
    Gary
    Participant

    I think I got a bad AR2412…Ugh.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.