Show recall fail (NVData CRC error )

Forums › Forums › SQ Forums › SQ troubleshooting › Show recall fail (NVData CRC error )

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Mike C Mike C 3 years, 8 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2020/08/02 at 6:20 pm #93795
    Profile photo of Drefuss
    Drefuss
    Participant

    Hello i have an SQ-5 firware 1.5.0
    For the first time i have not been able to load a Saved show today The error message is ( NVData CRC error ) is anybody had that problem ??

    2020/08/02 at 7:35 pm #93796
    Profile photo of Drefuss
    Drefuss
    Participant

    I have 3 shows on 17 on my USB key that give me this error when i want to load them

    2020/08/02 at 9:15 pm #93797
    Profile photo of volounteer
    volounteer
    Participant

    @drefuss

    try your backups and see if they have the same problem
    could be errors on your usb key now

    2020/08/03 at 1:28 am #93807
    Profile photo of Mike C
    Mike C
    Participant

    Where the backed up scenes on the USB created and backed up when using
    an older firmware version on the SQ?

    I had that issue on my QU, thankfully I only lost a couple scenes that were not
    too complex.

    Before creating a new updated back up I went through all the older scenes stored in the mixer, loaded them and them re-saved them. That way they were saved under the latest
    firmware version before backing up to the USB.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.