Selecting channels above channel 16 on ME-1

Forums › Forums › ME Forums › ME general discussions › Selecting channels above channel 16 on ME-1

Tagged: 

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of Mario Mario 7 years, 10 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2016/06/15 at 12:21 am #56604
    Profile photo of Mario
    Mario
    Participant

    We are using the QU-PAC and the AR2412 dsnake. I’m trying to select channels above channel 16 on my ME-1. It doesn’t seem to bring up the channels and names that are above channel 16 even though it’s set up on the QU-PAC. IE – channel 17 is named VOX1 and is configured and set up on the QU-PAC. But the ME-1 is not showing it. What am i doing wrong?
    Thanks!

    2016/06/15 at 7:33 am #56610
    Profile photo of Nicola A&H
    Nicola A&H
    Keymaster

    Hi Mario,

    Check the outputs in the Monitor tab (Setup / I/O Patch). You can patch any combination of inputs and mixes to the ME-1, perhaps channel 17 and higher are unassigned?

    Does the ME-1 key setup / source assignment list all sources with their names?

    2016/06/15 at 12:44 pm #56619
    Profile photo of Mario
    Mario
    Participant

    Thank you Nicola! I’ll try that.

    2016/06/15 at 9:57 pm #56634
    Profile photo of Mario
    Mario
    Participant

    It worked, Nicola. Didn’t have my I/O Patch set up right.Thank you!
    Mario

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.