Running subs through matrix

Forums › Forums › SQ Forums › SQ general discussions › Running subs through matrix

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2019/02/14 at 3:28 pm #81963
    Profile photo of samabeniesamabenie
    Participant

    We currently have our mains coming in as 1 XLR and our subs coming in as 1 1/4″. We have a crossover point and all that set up correctly. However, on the board I am trying to figure out how to best route it. On our old board we had it coming in as an AUX. Currently, I have it patched to “MAIN L/R”. However, I would like to pass it through a matrix to get more control. I was reading the reference guide and it says this is a possibility. How would I do that on the I/O or routing screens?

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.