Reset single frequency band in graphic equalizer

Forums Forums Avantis Forums Avantis feature suggestions Reset single frequency band in graphic equalizer

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Yvo Yvo 2 days, 8 hours ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #110697
    Profile photo of Juergen569
    Juergen569
    Participant

    On other consoles (e.g. SQ, QU, GLD), I can reset a single frequency band in the graphic equalizers by pressing the “sel” button (by using the GEQ fader flip). The Avantis does not have the “sel” button, but it would be greeat, if there was an other possibility to do such a reset.

    #110843
    Profile photo of Juergen569
    Juergen569
    Participant

    Found the solution on the Avantis: when you press and hold the RESET button, you can give a nugle to the faders. In GEQ-mode this will flip the fader back to 0dB.
    But this method can also flip any fader (Input, Mix, Matrix, etc) either to 0dB or to -00dB, depanding on the direction of the nugle to the fader.

    #111174
    Profile photo of Yvo
    Yvo
    Participant

    nice but I suppose that only works with GEQ flipped to the physical faders?
    Would be nice to be able to do it in the GUI too.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.