Recording with SQ5 over Dante

Forums Forums SQ Forums SQ general discussions Recording with SQ5 over Dante

Tagged: , , ,

This topic contains 7 replies, has 4 voices, and was last updated by Profile photo of SteffenR SteffenR 3 years, 7 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #94396
    Profile photo of Simon
    Simon
    Participant

    Hi guys,

    here’s an overview of my system:

    SQ5 connected to DT168 over a Dante network. An iMac is also connected to the Dante network via a switch.

    I can route audio from the DT168 to Logic X but I can’t seem to route audio from the SQ5, is this possible? Is there a setting I need to change on the SQ5 channel strip?

    My Dante Controller shows everything is connected with green ticks but no audio passes to Logic??

    Attachments:
    You must be logged in to view attached files.
    #94398
    Profile photo of SteffenR
    SteffenR
    Participant

    and what have you done inside the SQ?
    if you send nothing to the Dante Card it will not transmit anything

    #morescreenshotsplease

    #94399
    Profile photo of Mfk0815
    Mfk0815
    Participant

    On the SQ you have to route some signals to the dante card outs. Either tie lines, channel direct outs, mix bus outs …

    #94400
    Profile photo of Simon
    Simon
    Participant

    That’s my question, what do I need to do in the SQ and how?

    How do I ”tie” Channel 1 to the Main LR AND send it over Dante into Logic?

    #94401
    Profile photo of SteffenR
    SteffenR
    Participant

    how about reading the manual first?
    or google a bit?

    we should not have to explain everything

    #94403
    Profile photo of ioTon
    ioTon
    Participant

    Routing is done in the SQ on the I/O Screen.
    This Matrix is important.
    There you decide where the signals go to.
    greetings

    #94435
    Profile photo of Simon
    Simon
    Participant

    @steffenr I bet you’re a bundle of laughs at parties! Please don’t comment on any of my posts in future you’re most unhelpful, arrogant and rude.

    #94438
    Profile photo of SteffenR
    SteffenR
    Participant

    thank you
    did you read the manual?

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.