Recording clean inputs while using AMM

Forums Forums SQ Forums SQ general discussions Recording clean inputs while using AMM

Tagged: 

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of Dependable Dependable 2 weeks, 4 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #100392
    Profile photo of Dependable
    Dependable
    Participant

    Hi,
    I’m new to the QU5. If we use AMM for a PA feed of a discussion but want to record the pre AMM audio is that possible – or is gain sharing adjusting the input gain of each source so recording the individual channels will record their auto gain adjustment?
    Thanks
    Richard

    #100394
    Profile photo of ioTon
    ioTon
    Participant

    Hi Richard,
    As you can see in the SQ5 Signal flow diagram, the AMM controls the Volume AFTER the delay and BEFORE the mute + fader.

    So to record the channel without AMM you can use almost every thing but not “post delay”.
    You can use tie lines, auxes, direct out!
    Pay attention that they are not set to “post delay”!

    All the best!

    Attachments:
    You must be logged in to view attached files.
    #100397
    Profile photo of ioTon
    ioTon
    Participant

    The input gain will never be changed or effected by the AMM.

    You can see the AMM as an additional fader for the cahnnel!

    #100412
    Profile photo of Dependable
    Dependable
    Participant

    Thanks All. Really helpful

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.