R72 keeps switching fader banks randomly

Forums › Forums › iLive Forums › iLive troubleshooting › R72 keeps switching fader banks randomly

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of SteffenR SteffenR 5 years, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2018/10/31 at 7:09 pm #79663
    Profile photo of Triggerflanke
    Triggerflanke
    Participant

    Hi all,

    a little problem occuref on my r72: The surface kerps switching between faderbanks (layers) randomly. A to C or whatever. This occurs on both, input and output section.

    Any ideas ablut that? Happened after a master reset if surface via dip switches.

    Is there any way to perform a factory reset to get this desk like new out of box? Or to oversrite the 1.94 firmware again?

    The whole system runs on latest firmware.

    Thanks for your support 🙂

    2018/11/06 at 1:24 pm #79822
    Profile photo of SteffenR
    SteffenR
    Participant

    sounds like a hardware issue, a broken board or something similiar

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.