QU24 v1.7 Firmware Problem?

Forums Forums Qu Forums Qu troubleshooting QU24 v1.7 Firmware Problem?

This topic contains 21 replies, has 12 voices, and was last updated by Profile photo of GaryB GaryB 8 years, 11 months ago.

Viewing 7 posts - 16 through 22 (of 22 total)
  • Author
    Posts
  • #46804
    Profile photo of mervaka
    mervaka
    Participant

    1) Go to the processing screens, go to the preamp screen.
    2) Press the Fn button to bring up the source screen.
    3) Select all channels, set them all to dsnake.
    4) Go back to the preamp screen.
    5) For each input channel, make sure phantom power is off.

    For each saved scene, recall it, repeat the above steps, then store it again.

    For each saved show, repeat the above steps including those for scenes.

    Once complete, power cycle the desk.

    #46841
    Profile photo of james
    james
    Participant

    It worked…just like you said it would. Thank you very much!! All up and running again.

    #47276
    Profile photo of Nicola A&H
    Nicola A&H
    Keymaster

    Please note that V1.71 firmware released today addresses the issue discussed above.

    #47279
    Profile photo of GCumbee
    GCumbee
    Participant

    Thanks Nicola. Anything else in 1.71?

    #47355
    Profile photo of gim
    gim
    Participant

    Hello

    I just upgrade my qu24 to 1.71 and now the led on gate stay always on.
    Perhaps is normal, but, if I have nothing connect on the channel and the GR led is on.
    Of course if I have some signal the GR led go off, but if have no signal it’s not necessary to keep the GR led on !
    I don’t remember if in the previous version the led is stay on or not ?

    #47359
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    How do you tell if a channel is quiet or there is no signal?

    The gate will be active in either case

    #47631
    Profile photo of GaryB
    GaryB
    Participant

    I have been having a similar problem, but I’ve only had my Qu-24 for 3 weeks, and it came with 1.70, not an update. I figured out on my own – just by chance – the toggling of the phantom power on the couple channels that stopped working last week. Now I’ve done the firmware update to 1.71-4185, so we’ll see how that goes.

    I’m not using a dSnake, either.

Viewing 7 posts - 16 through 22 (of 22 total)

You must be logged in to reply to this topic.