Qu sb Aux 1 pre EQ

Forums Forums Qu Forums Qu troubleshooting Qu sb Aux 1 pre EQ

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #63959
    Profile photo of OwenOwen
    Participant

    At the risk of embarrassing myself on a public forum, can anyone point me in the direction of making Aux 1 on the Qu Pad post EQ? Aux 2 is and I am guessing that 3, 4, 5, 6 etc are but 1 is not. I cannot seem to track down the command to change that. HPFing things has no effect in the monitor driven by Aux 1 even though it does in FOH. Sorry if this has been asked before, I could not find it and I have tried to read the manual, honest.

    TIA

    #63961
    Profile photo of AndreasAndreas
    Moderator

    Select a mix and go to the routing screen, there you have a selection for the “Channel Source”.
    Its described with more detail in chapter 9.9 in The Manual.

    #63964
    Profile photo of GigaGiga
    Participant

    As Andreas said; tap the little arrow to the right below “tap to name”.

    Also, don’t forget you have 2 eq’s per aux/mix available to hone your wedges’ tone.

    Good luck !

    Giga

    #63965
    Profile photo of OwenOwen
    Participant

    Thanks both of you. I knew it was there, I just could not find it!

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.