Qu pad – How to control mains

Forums › Forums › Qu Forums › Qu troubleshooting › Qu pad – How to control mains

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of [XAP]Bob [XAP]Bob 8 years, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2015/08/12 at 8:52 pm #49784
    Profile photo of WMD Bluegrass
    WMD Bluegrass
    Participant

    Just upgraded firmware to v1.7 and see the Qu pad interface is different. I see how to switch between mixes but cannot figure out how to switch to LR/Mains. Any suggestions?

    2015/08/12 at 10:52 pm #49785
    Profile photo of Dick Rees
    Dick Rees
    Participant

    I’m still on v1.5, but the app should still mimic the board itself. A second tap on the Mix icon should put you back to L/R.

    2015/08/13 at 10:17 pm #49812
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    There should be an FOH button at the top of the list of Mixes…

    There is – it’s called LR and it’s above the FX sends…

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.