QU-Drive and USB Hub

Forums › Forums › Qu Forums › Qu troubleshooting › QU-Drive and USB Hub

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Wilts Wilts 9 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2015/04/15 at 11:08 am #46984
    Profile photo of Wilts
    Wilts
    Participant

    I have an existing USB hard drive (Seagate touch and go) that appears to be a bit flaxy as a Qu-Drive on a QU-32. I suspect the problem is that the USB port needs a bit more than 500mA since when I used it on a mac, I had to use one of those bodge cables which draws power from two USB ports. Hence I used to use a powered USB hub between the HD and the mac. Can the same trick be used with a QU-32 – that is, can I use a USB hub between the mixer and the HD?

    Paul

    2015/04/15 at 11:36 am #46985
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    I doubt it, but you could run a powered hub into one of those bodge cables.

    2015/04/16 at 9:05 am #47040
    Profile photo of Wilts
    Wilts
    Participant

    Tried using a hub last night – yep, doesn’t work!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.