Qu 24 DAW separate channel recording

Forums Forums Qu Forums Qu general discussions Qu 24 DAW separate channel recording

This topic contains 7 replies, has 5 voices, and was last updated by Profile photo of [XAP]Bob [XAP]Bob 7 years ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #62127
    Profile photo of pavelljubicic10
    pavelljubicic10
    Participant

    Hi to everyone!

    I am new to Qu 24 and I want to know how can I record separate channels from Qu 24 to Cubase(Windows)

    Thank you for replies

    Sincerly,

    Pavel Ljubicic

    #62128
    Profile photo of dpdan
    dpdan
    Participant

    connect a USB cable from the USB B connector on the rear of the console to your computer,

    Open Cubase,

    Make sure your audio interface for Cubase is set to the Qu,

    Create 24 tracks (or however many you want to record)

    Set the sample rate of Cubase to 48K 24 bit,

    Hit Record

    #62145
    Profile photo of pavelljubicic10
    pavelljubicic10
    Participant

    I did it and it’s still recording it as few channels in one track.I want to record one channel one track.

    #62146
    Profile photo of SteffenR
    SteffenR
    Participant

    How about reading the Cubase manual?

    #62147
    Profile photo of MarkPAman
    MarkPAman
    Participant

    I don’t use Cubase, but unless it’s very different to other DAWs, you need to select the source for each channel you want to record.

    #62152
    Profile photo of dpdan
    dpdan
    Participant

    MarkPAman nailed it!

    Well, so did Steffen 🙂

    #62165
    Profile photo of pavelljubicic10
    pavelljubicic10
    Participant

    Never mind I figured it out.

    #62169
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    And for the next person with the same question?…

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.