Qu-16 – Assign ST1 to CH15-16?

Forums Forums Qu Forums Qu general discussions Qu-16 – Assign ST1 to CH15-16?

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Mike@SCS Mike@SCS 3 weeks, 2 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #107468
    Profile photo of Mike@SCS
    Mike@SCS
    Participant

    Is there a way I can route ST1 to channels 15 and 16 on my Qu-16? I have my laptop connected to my Qu-16 via USB, and I want to be able to control laptop music levels using CH15-16 faders (linked) so I don’t have to keep swapping layers, as my mics are in CH1-12.

    #107469
    Profile photo of Giga
    Giga
    Participant

    Nope, but as an alternative you could add the ST1 fader to whichever custom layer you want 👍

    Good luck !

    Giga

    #107470
    Profile photo of Mike C
    Mike C
    Participant

    If using an iPad you have three custom layers. On the QU16 surface you can create a custom layer, go to the set up menu, control, custom layer.
    To access the custom layer you press the two layer buttons at the same time.
    Do that you can assign the channels you need to be in the same layer.

    #107471
    Profile photo of Mike@SCS
    Mike@SCS
    Participant

    Thanks. Assigning channels in the custom layer, including ST1 to 16, gives me the single-layer control I’m looking for.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.