Problems with channel “Soloing”

[Nheemstra]

After updating my CQ-12T to firmware V1.2.0 when I solo a channel to listen in my headphones it’s soloing the channel Post Fader instead of Pre-Fader, is there a setting that changed that I am unaware of. Before this update I was able to solo a channel and listen to it even if the fader was pulled down or the channel was muted.

Any advice would be appreciated.

[KeithJ A&H]

@Nheemstra

Input channels should be Pre Fade Listen and Output channels should be Post Fade Listen
If this is not what you’re getting, please try storing your settings as a show to a USB drive, then carrying out a hard/factory reset before testing again.
If loading your show back onto the unit reproduces the issue, please send us a copy of the show by submitting a ticket through support.allen-heath.com or by emailing support@allen-heath.com so we can look into this further with you.

Thanks,
Keith.

[Nheemstra]

All of my outputs are set to Post Fader.
There is nothing in the CQ-12T that will allow me to change the inputs to either Pre-Fader, or post-fader.

[SQuser]

> Before this update I was able to solo a channel and listen to it even if the fader was pulled down or the channel was muted.
I think in those cases you were listening to an input and are now probably doing so on an output (where PreFL is not possible).

[Author]

Posts