Preamp, phantom, pad control of DT168

Forums Forums SQ Forums SQ general discussions Preamp, phantom, pad control of DT168

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of rottmat rottmat 4 years, 3 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #85218
    Profile photo of Musician
    Musician
    Participant

    Hi everyone,
    Did anyone managed to control the preamps of DT168 from the SQ-7 Mixer?

    I have already tried the following:
    a) use dante controller to assign the stagebox inputs to the IO Port of the SQ7,
    b) assign the IO Port socket to an input channel

    However, the gain, phantom and pad are greyed out. Did i do it wrong?

    Appreciate any advice. Thanks.

    #85219
    Profile photo of Musician
    Musician
    Participant

    Just to add both DT168 and SQ7 have been updated to latest firmware version.

    #85223
    Profile photo of Alex A&H
    Alex A&H
    Keymaster

    Hi Musician,

    Please start a ticket at spport.allen-heath.com to discuss this.

    Thanks!
    Alex

    #85984
    Profile photo of Kieftenbelt
    Kieftenbelt
    Participant

    Thing I forgotten to do, if people are reading this with the same issue, is to (of course..) connect them in the Dante Controller, that the inputs are transmitted on the SQ dante card. After that the preamp controls works!

    #88455
    Profile photo of rottmat
    rottmat
    Participant

    It would be nice zo control this things without a mixer. For example over the dante Controller

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.