Pre-Sale question – how to connect

Forums Forums dLive Forums dLive General Discussions Pre-Sale question – how to connect

This topic contains 4 replies, has 2 voices, and was last updated by Profile photo of Scott A&H Scott A&H 7 years, 7 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #57518
    Profile photo of Albin
    Albin
    Participant

    Hi.
    Was an long time ILive user – and currently searching for a new System.

    I am interessted in buying an DM32 along with and IP6 and an IP8 – but no surface.
    So my question is this:
    How do i connect the IP6 if this should stay on stage next to the MixRack and then run a single CAT5 Cable to FOH to connect an
    PC for use with Director Software and the IP8 (for having a couple of faders).

    How would the system be connected – and is this even possible (with ans single CAT5 Cable?)?

    Thanks in advance.
    Albin

    #57523
    Profile photo of Scott A&H
    Scott A&H
    Participant

    Hello,

    FOH – Director & IP8 go into a switch (Switch-If you don’t want to use the IP power supplies you need a POE+ switch for the IP8)
    1 CAT5 Cable from the FOH switch to Network Port 1 on the DM MixRack.
    Stage – IP6 Into Network Port 2 on the DM MixRack.

    Support A&H.

    #57525
    Profile photo of Albin
    Albin
    Participant

    Ok, thank u.
    I had a look at Director and tried to find how to configure the IP8 offline.
    Is this not implemented yet or did i just not find it?

    Albin

    #57528
    Profile photo of Scott A&H
    Scott A&H
    Participant

    Yes, you can configure IP Controllers offline in Director, from V1.30.

    #57529
    Profile photo of Scott A&H
    Scott A&H
    Participant

    Information and system examples available on the A&H website –

    IP6

    IP8

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.