Power up order and driver detection

Forums › Forums › SQ Forums › SQ general discussions › Power up order and driver detection

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of SteffenR SteffenR 4 years, 7 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2019/08/22 at 10:33 pm #85985
    Profile photo of whatsoup
    whatsoup
    Participant

    I understand it is recommended to turn an audio interface on before the PC is powered on, but I’m pretty sure I used to ‘get away’ with turning on the SQ-5 after the PC had booted and have the driver be detected in my DAWs.

    These days I can’t get the driver to show if I turn on the SQ-5 post boot. Am I imagining it, or is there people out there not having to reboot before they use their SQ driver?

    2019/08/23 at 2:42 pm #85999
    Profile photo of SteffenR
    SteffenR
    Participant

    it should be “Plug And Play”
    depends on the settings of the OS and the DAW

    2019/08/27 at 11:43 am #86065
    Profile photo of whatsoup
    whatsoup
    Participant

    You must be right. I think I messed with some device permissions in Windows 10 now I think about it. Finding it again is the hard part. I’ll keep looking, thanks

    2019/08/27 at 10:02 pm #86084
    Profile photo of SteffenR
    SteffenR
    Participant

    reinstalling the driver with a reboot in between could help
    much luck

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.