Playing backing tracks from my iphone

Forums Forums CQ Forums CQ General Discussions Playing backing tracks from my iphone

This topic contains 6 replies, has 3 voices, and was last updated by Profile photo of KeithJ A&H KeithJ A&H 2 months, 2 weeks ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #118851
    Profile photo of Dinomite34
    Dinomite34
    Participant

    Is their a way to play backing tracks from my iPhone using bt or the built in wifi?

    #118852
    Profile photo of willmodelisme
    willmodelisme
    Participant

    Using BT only for music. Wifi is only use for the app controls.

    #118853
    Profile photo of Dinomite34
    Dinomite34
    Participant

    Ok… I can’t seem to figure out how to bring the music in to the mixer?
    I couldn’t find anything on this in the manual…

    #118857
    Profile photo of Dinomite34
    Dinomite34
    Participant

    Somehow after trying it again and again it worked!

    #118986
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    Glad you got it going, but for anyone else who comes across this thread who needs help with CQ Bluetooth connection and setup, please see the following article – https://support.allen-heath.com/hc/en-gb/articles/19212933662865-Connecting-a-Bluetooth-device-to-CQ-for-audio-playback

    Thanks,
    Keith.

    #118987
    Profile photo of Dinomite34
    Dinomite34
    Participant

    Keith… thanks for getting back to me….

    Can you help me or lead me to the right place for this:

    I am using an Alesis Strike Pro kit and want to output the kit sounds from easy drummer to my mixer but want to be able to have all my instruments go through on separate outputs for separate control. At the moment I can only send to the mixer through the out of my module. My module has 7 outs and I plug them into the mixer but only get module sounds…

    I want to be able to practice with the ezd kit sounds and because my cq18t records would like to use that as well and then take the recording to post if desirred.
    Also, I would like this setup for gigs as well…. Is this possible?

    I hope this makes sense!

    #118998
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    @dinomite34

    You need to set the CQ USB Stream Mode to Multitrack – https://www.allen-heath.com/content/uploads/2023/09/CQ_User_Guide_V1_1_0_iss1.pdf#page=64&zoom=auto,-361,555
    Then connect via USB-B to your computer and use the CQ as the audio interface, setting each output from EZDrummer to different CQ USB channels (not sure if you can do this directly or need a DAW).
    Finally, on the CQ switch the input source for each of the channels you’re using to USB/SD (symbols) in the bottom left of this screen – https://www.allen-heath.com/content/uploads/2023/09/CQ_User_Guide_V1_1_0_iss1.pdf#page=60&zoom=auto,-361,535

    This should give you individual outputs from EZDrummer on separate channels of the CQ.

    Cheers!
    Keith.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.