PL-anet pin-out diagram

Forums › Forums › iLive Forums › iLive general discussions › PL-anet pin-out diagram

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2014/05/21 at 9:22 am #39861
    Profile photo of SylvesterSylvester
    Participant

    Hi all,

    Anyone know if there exist a pinout diagram for the RJ45 connector in the PL-anet remotes? Are all 8 leads in use, or could a 5-pin/7-pin XLR connector be used for connecting the remotes?

    2014/09/17 at 4:31 pm #41707
    Profile photo of KB7981KB7981
    Participant

    This is the user guide for the pl-4. It shows using 2 of the 4 pairs for a 20volt power source. I presume at least one other pair is for control. In fact, on the card at the PL-Anet port it warns……

    “CAUTION 20V DC
    TO AVOID DAMAGE ONLY CONNECT
    COMPATIBLE REMOTE CONTROL EQUIPMENT TO THE PL-ANET PORT.”

    Attachments:
    You must be logged in to view attached files.
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.