PEQ In/Out

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Markussannan Markussannan 4 years, 6 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #62411
    Profile photo of Jay
    Jay
    Participant

    S-5000, 1.41

    I see the Input PEQ in/out shown in Director on the lower left side of the page but not on the surface. Is it someplace I am missing it?

    The GLD screen also shows a “Flat” button, but not anywhere to be found on dLive. Again, someplace I’m not looking?

    Thanks,

    Jay

    #62416
    Profile photo of ahjeff
    ahjeff
    Moderator

    Hi Jay

    If you hold the ‘Reset’ key, you should be able to reset the GEQ to flat in any of the Bank, Overview, or GEQ screens.

    Cheers

    – Jeff, A&H

    #62433
    Profile photo of Jay
    Jay
    Participant

    Jeff,

    Reset addresses the issues of PEG & GEQ on the surface – still leaves some outstanding questions:

    – Surface, where is in/out for PEQ?
    – Director, where is “reset” for PEQ/GEQ?

    Jay

    #62434
    Profile photo of Markussannan
    Markussannan
    Participant

    See the image for where the PEQ in button is located on the surface.
    In Director you have the copy/paste/reset buttons located just to the left of the Main/PAFL meter.

    Attachments:
    You must be logged in to view attached files.
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.