Output for monitors not working

Forums › Forums › CQ Forums › CQ troubleshooting › Output for monitors not working

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2023/12/13 at 8:10 pm #117457
    Profile photo of Scottsville69Scottsville69
    Participant

    Mains work fine and get signal through inputs, however i cant seem to get my monitors to work through the outputs. Cables works fine and latest firmware is installed. Im sure im doing something wrong. The unit is brand new!

    2023/12/13 at 8:50 pm #117459
    Profile photo of JayDeeJayDee
    Participant

    This may be obvious, but make sure that the channel fader is turned up in the Mains section as well as the Monitor section that you’re using.

    2023/12/14 at 3:26 am #117469
    Profile photo of JayDeeJayDee
    Participant

    I’m sorry. Disregard my previous post. For some reason I was thinking of you problem as reverb not working.

    2023/12/21 at 2:01 am #117678
    Profile photo of Mike CMike C
    Participant

    Have you selected the sends on fade mode for the mix you want to use and then bring up the channel send level fro the channels you want to that mix and is the master for the mix turned up?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.