Newbie – QU-16 mix group tied to main fader

Forums › Forums › Qu Forums › Qu general discussions › Newbie – QU-16 mix group tied to main fader

Tagged: 

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • 2023/02/14 at 1:09 am #111504
    Profile photo of dboudahdboudah
    Participant

    On our QU-16 we use Mix 10 for an output to our powered subwoofers. If we bring down the Master LF fader the subwoofer volume on Mix 10 stays the same and the mix is now out of balance. What is the best way to set up the QU-16 so if I turn the entire band down a bit by lowering the master fader that the Mix 10 volume also comes down proportionately? thanks

    2023/02/14 at 8:53 am #111506
    Profile photo of RichardRichard
    Participant

    I believe you have to change Mix10 to post fader or opposite of default. Pre-fader I think. We had the same issue and we had a sound engineer help us with that issue.

    2023/02/14 at 9:54 am #111509
    Profile photo of GigaGiga
    Participant

    DCA with LR + Mix 10.

    Giga

    2023/02/14 at 2:29 pm #111514
    Profile photo of Lee7Lee7
    Participant

    @Giga

    QU-16 doesn’t have any DCA’s.

    2023/02/14 at 3:08 pm #111517
    Profile photo of ScottScott
    Participant

    THe Qu-16 does have 4 DCAs. You just have to add them to the custom layer.

    2023/02/14 at 3:56 pm #111521
    Profile photo of Lee7Lee7
    Participant

    @Scott,

    So it does, for some reason I thought it was only the bigger channel count mixers that had those.

    2023/02/14 at 6:42 pm #111530
    Profile photo of GigaGiga
    Participant

    Glad that’s sorted. I was going to say “but the app does” 🙂

    Giga

    2023/02/14 at 10:10 pm #111536
    Profile photo of dboudahdboudah
    Participant

    Giga, thank you. That’s what I will do.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.