Mono/c bus

Forums Forums SQ Forums SQ feature suggestions Mono/c bus

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of ilya20008 ilya20008 4 years, 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #87475
    Profile photo of ilya20008
    ilya20008
    Participant

    Hi!
    I’m very used to using the mono bus. I was annoyed when I found out about the lack of this feature. In my opinion it would be possible to add a mono bus as well as groups or auks, but that would have been the ability to send AUX and groups
    Please consider my proposal

    #87482
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    Hi @ilya20008,

    Depending on what you are wanting to use this for, you could utilise a mono matrix, which then gives you extra processing including GEQ, PEQ and Compression.
    This could either be fed solely from the LR mix, or by any combination of mix busses.

    Thanks,
    Keith.

    #87519
    Profile photo of ilya20008
    ilya20008
    Participant

    Unfortunately, it is not possible to send a signal from the input channel to the matrix bus, and it is wasteful to use an additional AUX bus

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.