Mixpad Fails to connect to SQ5

Forums Forums SQ Forums SQ troubleshooting Mixpad Fails to connect to SQ5

Tagged: 

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Beataning39 Beataning39 2 years, 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #104245
    Profile photo of Tjeerd B
    Tjeerd B
    Participant

    I’m using a Netgear Nighthawk M2 directly connected to my SQ5
    My Ipad Pro and the SQ5 both receive an IP-adress through DHCP (Ipad 192.168.1.22 – SQ5 192.168.1.21)
    When I open the SQ mixpad, the software shows the SQ5, but whenever I hit the ‘connect’ button, after a few seconds the SQ mixpad shows: ” Failed to connect, Unit discovery timed out’

    Firmware SQ5: 1.54 r3979
    Firmware SQ mixpad: 1.5

    Does anyone know what I’m doing wrong and what I can do to make it work?
    Thanks for the effort and I look forward to your reaction.

    Kind Regards

    #104246
    Profile photo of Mike C
    Mike C
    Participant

    Try setting a static IP on the mixer.

    You’ll need to configure the router so the DHCP handout range does not conflict
    with the static IP on the mixer.

    Say the mixer is set to 192.168.1.10 the DHCP range on the router could start at 192.169.1.100.

    #104513
    Profile photo of Beataning39
    Beataning39
    Participant

    tried mine it works what mike suggested!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.